Safety Screen

A protective screen is sometimes a necessary accessory to protect the operator in the event of sample fragments leaving the test area during a test. 

A Safety Screen is available for operator protection from such fragments or violent failures of specimens such as hard and brittle materials that may shatter or create projectiles upon failure. In addition, there are instruments used by multiple and/or unskilled operators that may prefer the installation of such a screen for an extra degree of operator safety. 

The screen is constructed of a strong yet lightweight acrylic panel which allows clear observation during a test whilst minimising weight. A handle at the front of the instrument provides the means to lift the screen. An interlock mechanism requires that the screen is at its lowest 'closed' position prior to starting a test and will interrupt the test in the event that the screen is lifted up during a test. Upon lifting, any test that is underway will immediately stop and an audible signal will be produced. The screen has dampers which enable the panel to remain at any lifted position without dropping down. 

The design is such that the screen works within the existing footprint of the Texture Analyser with no additional bench space required.

Full installation instructions are provided within the Education Zone of the latest Exponent/Connect software version and on the technical information sheet accompanying this product.

Stable Micro Systems probes and attachments are commonly made from four materials: anodised aluminium (AA6082 T6), stainless steel (316 T), Delrin (acetyl copolymer) and Perspex (polycarbonate).

In general use, probes and attachments made from these materials will be suitable for testing food products and inert non-food materials.

The four materials listed above are not universally resistant to all types of chemicals and as such the compatibility of the probe/attachment material with the product (to be tested) must be established to prevent damage to the probes and attachments. If the compatibility of the product with the probe is unknown to the customer then the chemical information about the product (Material Safety Data Sheet or Product Data Sheet) should be submitted to Stable Micro Systems. Stable Micro Systems will then assess the suitability of the probe/attachment material for use with the product and advise accordingly. If this advice is not sought then Stable Micro Systems will not accept liability for probes/attachments damaged by chemical attack from the product being tested.

May be wiped with a soft cloth in warm (or hand hot) water using a mild detergent. A soft brush may be used but abrasive cleaning aids should be avoided. Stable Micro Systems products should not be microwaved or cleaned in a dishwasher.